PDF Manual Installation Guide of 2004-2007 Ducati ST3/ST4 Sport Motorcycles

This book about Ducati ST3/ST4 Sprort Motorcycles Guide. This is truly best sport motorcycles with high speed from ducati manufacturer. If you have this sport motorcycles, you should read this online manual books. So, you can know the information how to installation instruction manual, and service manual, maintenance schedule for the best motorcycles performance. Here it is the online pdf books content previews:

Heli Bars are designed to safely increase your riding comfort, however it is imperative that these instructions be followed to ensure correct installation. Failure to follow these instructions could result in improper installation and create a dangerous control situation. If you have questions about installation call Heli Modified, Inc. at 1-800-859-4642. NOTE: Heli Bars for the ST3 and ST4 are designed to utilize the factory bars and replace the stock mounting lugs only. Remove the front brake master cylinder from the right handlebar. It is NOT necessary remove any other controls or grips. 1: A. Loosen clutch banjo bolt at the clutch master cylinder just enough to rotate the banjo fitting forward 3/8”(measured at the bottom of the steel fitting where the rubber line begins). Refer to PHOTO#3 for angle assistance. Re-tighten. B. Repeat step A on the front brake banjo fitting at the master cylinder and reposition. Loosen the front brake hold down strap bolted to the front of the lower triple clamp. Loosen the rubber grommet from it’s stock position and slide down about 1”. Pull the line up and re-tighten the hold down strap. Refer to photo #2. 2. Loosen and remove the four screws (6mm w/5mm hex head) that attach the bars to the mounting lugs. Place a rag around the bars and controls and rest them on the fairing. 3. Carefully remove the top triple clamp. Gain access to the steering stem pinch bolt by removing the black forward tank cover. 4.Remove the left and right factory bar lugs from the fork tubes. 5. Slide the left and right Heli Bar lugs over the fork tubes. Slide them down as far as they will go until they hit the fork tube taper. The left and right Heli Bar lugs are easy to identify. The risers are positioned outside the fork tubes and the Heli logos can be read from the saddle….(download for more instruction)

If you are interesting to download, follow this download information links from the original source at this website: Installation Instructions Manual Books 2004-2007 Ducati ST3/ST4 Sprort Motorcycles.pdf. We hope this online manual books useful for you.